Come faccio a capire qual'è il mio livello di deepsleep se da terminale leggo questo?
u0_a2@android:/ $ su
root@android:/ # cat /d/cpuidle/stats
| CPU0 | CPU1 |
| Online | 100%, 609054 ms | 99%, 606009 ms |
| Wake-ups per s | V | V |
| CPU0 | CPU1 | CPU0 | CPU1 | CPU0 | CPU1 | Both | Both | Both | Hit | TO |
Idle states | (ms) | (ms) | (#) | (#) | (%) | (%) | (ms) | (#) | (%) | (%) | (%) |
0 | Running | 247327 | 331960 | 363368 | 469628 | 41 | 55 | ? | ? | ? | V | ? |
1 | Wait for interrupt | 361723 | 274048 | 363368 | 469626 | 59 | 45 | ? | ? | ? | V | ? |
2 | ApIdle | - | - | - | - | - | - | 0 | 0 | 0 | V | ? |
3 | ApSleep | - | - | - | - | - | - | 0 | 0 | 0 | V | ? |
4 | ApSleep, UL PLL off | - | - | - | - | - | - | 0 | 0 | 0 | V | ? |
5 | ApDeepsleep, UL PLL off | - | - | - | - | - | - | 0 | 0 | 0 | V | ? |
Idle/Sleep results from PRCMU:
V
Latencies:
M W
Reasons for ApIdle (#):
V
V = Only visible in verbose mode. echo 1 > verbose to enable.
M = You must enable measure latency. echo 1 > measure_latency to enable.
W = You must enable wake measurements. echo 1 > wake_latency to enable.
Hit = The rate of how often the deepest possible state was picked.
TO = Timed out, the percentage of wake up on programmed timeout.
PENINT = Pending interrupts.
PS = PRCMU success rate. The percentage of Idle/Sleeps that went ok.
RB = The rate of regulator use is blocking ApSleep
? = Measurement not implemented.