Chainfire ha appena rilasciato la versione del kernel cf@root per questo terminale qualcuno lo ha provato?
[18.06.2012] CF-Root 6.3 - SuperSU+CWM5.5+CWMManager - xda-developers
Come si installa (desktop) ODIN
Short: unpack the ZIP download, you will end up with a TAR, flash this in ODIN as PDA, and optionally install and run Triangle Away afterwards to reset the flash counter. Beware that this should boot your device into recovery mode (for a few seconds to install SuperSU and CWM Manager) after flashing. Sometimes it doesn't, just flash it again in that case.
Metodo rapido: scompattare il file ZIP una volta e troverete un altro file TAR, inseritelo nel campo PDA di ODIN e il gioco è fatto; dopo di che potete installare Triangle Away per resettare il counter. Attenzione questo metodo potrebbe far partire il vs. terminale in recovery mode (questo serve ad installare SuperSU e CWM Manager) appena dopo il flash. Può succedere che questo non succeda, in questo caso procedete con il flash ancora una volta.
Long:
- Follow these instructions to the letter. Do not touch any buttons or checkboxes that are not listed below to touch!
- Unzip the attached Odin3-vX.X.zip file
- Download and unzip the CF-Root-SGS3-vX.X.zip file (see posts below this one)
- If you end up with a recovery.img and cache.img file, you've extracted twice. You need to end up with a .tar file - don't extract that one
- (USB) Disconnect your phone from your computer
- Start Odin3-vX.X.exe
- Click the PDA button, and select CF-Root-SGS3-vX.X.tar
- Put your phone in download mode (turn off phone, then hold volume-down + home + power to boot - if it asks you to press a button to continue, press the listed button, or run adb reboot download command)
- (USB) Connect the phone to your computer
- Make sure Repartition is NOT checked
- Click the Start button
- Wait for Android to boot
- Done (if it took you more than 30 seconds, you need practise!)
Lungo:
- Seguite questa guida alla lettera non toccate nessun bottone o casella che non sia espressamente segnalata qua sotto;
- Scompattate Odin3-vX.X.zip
- Scaricate e scompattate il seguente file: CF-Root-SGS3-vX.X.zip file
- Se dopo aver scompattato il file vi ritrovate i seguenti recovery.img e cache.img files significa che avete scompattato due volte il file contenente il kernel;
- Scollegate il vs. terminale dalla porta USB;
- Lanciate Odin3-vX.X.exe
- Selezionate PDA ed inserite il file: CF-Root-SGS3-vX.X.tar
- Mettete il vs. terminale in Download Mode (classica combinazione dei tre tasti)
- Connettete il vs. terminale alla porta USB del vs. PC
- Assicuratevi che REPARTITION NON sia selezionata
- Selezionate START
- Attendete che Android riparta
- FATTO