Davvero strano:o
Visualizzazione stampabile
SiyahKernel v3.2
Posted on May 10, 2012
Changelog:
removed nandroid backup from/restore to 2ndROM. There is a problem which I have just noticed and it will take some time to fix that. Use swap&backup until I fix it.
default lower cpu step is set to 100MHz
your extweaks settings will be automatically reset after flashing this version
used Linaro toolchain 4.7 (2012.04) which let me use gzip without exceeding 8MB
http://www.gokhanmoral.com/public/fi...Siyah-v3.2.tar
http://www.gokhanmoral.com/public/fi...h-v3.2-CWM.zip
Niente io continuo a trovarlo poco fluido.. Proverò il profilo performance se no rimetto la 3.1.2
I lo trovo meno fluido delle altre versioni :/
Inviato dal mio GT-I9100 con Tapatalk 2
SiyahKernel v3.2.1
Posted on May 10, 2012
Changelog:
removed ntfs-3g from the payload part to make the kernel smaller (I want to enable LZO instead of GZIP). if you want ntfs-3g you can find it here
enabled kernel’s ntfs support to mount usb flashes in read-only mode
LZO, to have even faster booting
re-enabled j4fs and mounting of lfs partition (hellcat’s boot logo changer worked, even if it stuck with “working” popup, but it could successfully set my cat’s photo as a boot logo )
reverted 267MHz GPU voltage back to 1000mV. if you did not have a problem with v3.2, you can set it back to 950 (or even lower) with ExTweaks.
fixed vdd_levels interface. it was supposed to be using milivolts but I noticed that it was using microvolts when I tried to echoing it ‘-50′ to undervolt all steps by 50mV.
http://www.gokhanmoral.com/public/fi...yah-v3.2.1.tar
http://www.gokhanmoral.com/public/fi...v3.2.1-CWM.zip
Inviato dal mio GT-I9100
Qualcuno ha già provato?
Inviato dal mio GT-I9100 con Tapatalk 2